Hotpoint FDAL 11010 wont complete cycle

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Hotpoint FDAL 11010 wont complete cycle

Viewing 1 post (of 1 total)
  • Author
    Posts
  • August 17, 2022 at 9:33 am #101096
    Tom Wilde
    Participant

    Hi,

    hope someone here can point me in the right direction? I have a Hotpoint FDAL 11010 that gets about 10 mins into the cycle and then stops. Left set of LEDs flash (power / rinse aid / salt) indicating a fault and on the right side I see steady LEDs: start/pause, Wash and End. From this page here I think I have an ‘E11 Non-operative electronic control module‘ fault. I should point out the cycle does occasionally complete so the fault is transient.

    Any ideas?

    Thanks!

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.