Hotpoint FDL570 Dishwasher Fault

[Iain1]

Help Please Forum

I have the following fault with my Hotpoint FDL570 dishwasher:
The dishwasher fills as expected after pressing Start/Pause.
After filling the dishwasher immediatley pumps out all the water and flashes the following LEDs:
On/Off
Wash
End

The fault started out as intermittant and has got steadly worse so that it now occurs every time a wash cycle is started.

My initial analysis leads me to believe this may be the following error:
E7 Pressure switch error

I have checked the water inlet hose and associated filters and all is OK.

Any assistance in narrowing down this fault would be greatly appreciated

[electrofix]

would need more info as there are lots of these units with similar models but the one i pulled up

there are 3 lights on the right if i am correct. you have the top and bottom light lit plus the start light

that gives me fault 13 which is dead circuit board

to be certain i need to see a pic of the lights and the rest of the numbers from the label

Dave

[Iain1]

I have the photos but cannot upload them due to a very low 19.5 k byte file size limit. The photos file sizes are small (< 100k bytes each).

[electrofix]

you have to host it somewhere else and post a public link

Dave

[Iain1]

Dave,

https://ibb.co/7NnTQrW
https://ibb.co/d4T82d4
https://ibb.co/t3xLj7y

Control panel – Showing which LEDs are flashing. Note the On/Off, Start and End LEDs are flashing.
The Start/ Pause LED (you mentioned above) is not flashing.
Ident Labels – Hopefully enough to fully identify which model this is.

Many Thanks
Iain

[electrofix]

I see it as the on-off wash and end led’s are flashing the start button is off in your photo

I make that fault 5

Dave

[Author]

Posts