Hotpoint FDW70P D/W SN 510181239

[iadom]

Re: Hotpoint FDW70P D/W SN 510181239

mike412 wrote:

After following this thread, I too needed to fit one of these heaters. Sparing no expense I ordered 2x 9900250 clip v2.
I received, nicely packaged in Hotpoint polybags, two ordinary 60mm x12mm wide jubilee clips at £3.24each. I sent these back and used 2 x PLM70 hose clips off the van stock at 99p each. these seemed to do the job just fine, no real problems at all.

Regards,
Mike.

PLM70? were do you obtain those from, doesn’t show up on Masterpart/Qualtex lists.

Jim.

[Penguin45]

Re: Hotpoint FDW70P D/W SN 510181239

I haven’t destroyed an original clip yet……….

Chris.

[mike412]

Re: Hotpoint FDW70P D/W SN 510181239

Hi Jim.

I get PLM70 from Connect. Nothing unusual, I expect you can get them from B+Q, just ordinary 50-70mm Jubilee clips. I guess these are what Hotpoint are supplying to their engineers at this time, unless of course the ones I received were incorrectly packed. Has anyone else received these recently, or indeed the thin clips on this part number?

Regards,
Mike.

[admin]

Re: Hotpoint FDW70P D/W SN 510181239

No I ordered the Hotpoint ones but as you say exactly the same as
50-70mm jubilee clips…..but far more expensive……but the Hotpoint ones
were very bright finish!!!!
thats where the cost goes…….

col

[iadom]

Re: Hotpoint FDW70P D/W SN 510181239

Just checked on a couple of 9900250 V2 clips I received this week, one is a bog standard size jublilee clip as you say, the other is the narrow one, both in genuine labelled bags. 😕

Jim.

[hotpnt]

Re: Hotpoint FDW70P D/W SN 510181239

im with penguin on this one, fitted prob 50 or more heaters, always re-used the orgional clips without a problem

[johnnyj]

Re: Hotpoint FDW70P D/W SN 510181239

They changed the 9900250 clips they are wider and are hopeless there is another part no for them i’ll dig it out later.

[Author]

Posts