HOTPOINT HVL211uk

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HOTPOINT HVL211uk

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 26, 2010 at 12:49 pm #52822
    smeghead
    Participant

    hi all
    Machine fills for about 4/5 secs , then nothing. No spin either. On pump cycle, pump starts for 1 sec then nothing.
    After about 7/8 minutes door lock light rapid flashes & extra rinse light flash.
    Done all usual checks, nothing obvious.
    Any Ideas??
    Clive.

    February 26, 2010 at 1:13 pm #313278
    Martin
    Participant

    Re: HOTPOINT HVL211uk

    smeghead wrote:door lock light rapid flashes & extra rinse light flash.

    What position are these LED’s counting from top to bottom to give them numbers rather than names? Then look up the error code in the ERROR CODES thread. 😉

    February 26, 2010 at 6:46 pm #313279
    smeghead
    Participant

    Re: HOTPOINT HVL211uk

    doh! why didnt i think of that, its the fourth neon , so F01 motor triac.
    All connections are good so new pcb then.
    cheers Martin.
    clive.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.