Hotpoint Mistral: Display/No display boards

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint Mistral: Display/No display boards

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 29, 2005 at 5:27 pm #12269
    Simon46
    Participant

    Can i Fit a Control Module 260028 (no display)to an 8596P with display?
    No jokes about the temperatures will be difficult to see 🙂
    Regards
    Simon

    September 29, 2005 at 7:59 pm #148792
    Dave_Conway
    Participant

    Re: Hotpoint Mistral: Display/No display boards

    There’s one way to find out Simon but I doubt it to be honest 😉

    Dave.

    September 30, 2005 at 11:47 am #148793
    Simon46
    Participant

    Re: Hotpoint Mistral: Display/No display boards

    It was only going to be for test purposes due to compressor only running for a few minutes.Was not required.
    Fault found to be foam strip stuck in condenser fan jamming it.
    Another new fault cured. 😀

    S.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.