hotpoint wd 860

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wd 860

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 29, 2010 at 7:28 pm #55524
    Cras
    Participant

    this machine failed to work after a power cut (although not in use at time just plugged in ) customer reports that it first came up with h20 and then f 01 (motor triac) im presuming control board but is there anything else i should be looking for thanks Cras

    June 29, 2010 at 8:19 pm #324219
    Allsorts
    Participant

    Re: hotpoint wd 860

    check the hot and cold inlet vales first

    July 2, 2010 at 7:05 pm #324220
    Cras
    Participant

    Re: hotpoint wd 860

    job now sorted turned out to be control board which according to EMW is a common fault after a power cut . Cras

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.