- This topic has 0 replies, 1 voice, and was last updated 11 years, 3 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi
I have a Hotpoint WD420 that is showing an F4 error code, shortly after being started. This is apparently a pressure switch problem. I have replaced the switch, in the hope that this would fix the problem without a callout, but that hasn’t sorted it. Is there any other likely cause that I might fix myself?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.