hotpoint wd420 wont start

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wd420 wont start

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 10, 2012 at 5:11 pm #68869
    mikehha
    Participant

    G-day all I have just been to a wd420 that wont turn on!The third light down was flashing F02 but nothing wrong with the motor the only fault I have found is the dryer heater is open circuit.so I changed the lower board now the third light stays on not flashing.untill you turn the main prog knob then it goes off But you still cant turn the m/c ON any ideas!

    April 10, 2012 at 5:42 pm #373018
    BobHope
    Participant

    Re: hotpoint wd420 wont start

    when you changed the module did you programme it ?

    Bob.

    April 10, 2012 at 6:27 pm #373019
    mikehha
    Participant

    Re: hotpoint wd420 wont start

    direct from emw bob so I hope tony programmed it .mike

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.