Hotpoint WD640 Drier Heating when off!

This topic has 2 replies, 2 voices, and was last updated 16 years, 12 months ago by delahart.

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
April 10, 2009 at 7:06 pm #44917

delahart
Participant

Hi all,
We have just replaced a drier heater as it was tripping and the thermal link had failed. All seemed to be fine until after test and turning off it smelt hot and discovered drier heater powered up. I have no diag for this so presume it is a fault on board. Any one come across this before. Can’t see it in any posts after a quick look.
Cheers,
Delahart.

April 10, 2009 at 7:17 pm #282938

helo_75
Participant

has to be pcb, wire to element directly from board through thermal fuse

ive seen that before

April 10, 2009 at 7:33 pm #282939

delahart
Participant

Re: Hotpoint WD640 Drier Heating when off!

Thanks Helo 75,
I guessed it would be. could well be calling Tony at EMW.
Delahart.
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.