Hotpoint WD64P

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hotpoint WD64P

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 4, 2007 at 4:33 pm #31101
    andyhandy
    Participant

    Hi All,
    I have a Hotpoint WD64P washer/drier that requires a new door seal fitted. Can anyone advise me how to carry out this job?
    Many thanks
    Andyhandy

    October 4, 2007 at 5:33 pm #229662
    iadom
    Moderator

    Re: Hotpoint WD64P

    Not so handyandy after all. 😉 😀

    for safety reasons we cannot go into blow by blow details. Suffice it to say that if you remove the console and the cabinet front panel it should all become obvious. Only thing to watch out for is the dryer inlet vent at the top of the seal, two screws holding this need to be slackened off a little.

    All with the mains plug removed off course.

    Jim.

    October 4, 2007 at 7:52 pm #229663
    andyhandy
    Participant

    Re: Hotpoint WD64P

    Hi Jim,
    Many thanks for your help. Can you let me know what the console is?
    Many thanks
    andy

    October 4, 2007 at 7:55 pm #229664
    Penguin45
    Participant

    Re: Hotpoint WD64P

    Control panel where the knobs and switches are mounted.

    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.