- This topic has 4 replies, 2 voices, and was last updated 13 years, 5 months ago by
.
Viewing 5 posts - 1 through 5 (of 5 total)
-
Posts
-
Went to the above machine and cust had already taken out the module. I have matched up the wiring to the module and am happy with all connections except a connector with 2 black wires. It either goes to J15 or J16. I’ve looked carefully at the board but can’t see definite tagging marks on either? My guess is J16 but any help would be much appreciated. These boards are temperamental at the best of times without wiring them up wrong!
Many thanksRe: Hotpoint WD865 (ser no 802080059)
Went out to the job with Dragan’s info and a refurb EMW module. The leads (from the dryer fan) did go to J16 and all working fine.
Thanks again Dragan!
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.