hotpoint WDD960 F11

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint WDD960 F11

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 19, 2012 at 4:06 pm #70556
    johnnyhoz
    Participant

    Checked the sump hose was clear, it is pumping out at a good rate but it still comes up with F11 at the end of the programs and doesn’t spin except for coloureds program where it runs through with no fault and spins out normally, any thoughts please

    John

    July 26, 2012 at 10:26 pm #378378
    Muv
    Participant

    Re: hotpoint WDD960 F11

    My own WDD960 just gone the same way, last time it went,it was down to a loose main PCB connector…

    Although this time it won’t do the spin on any programme…
    Any ideas greatly appreciated… Tho I think it’s time for a new board from EMW

    Martin

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.