- This topic has 2 replies, 2 voices, and was last updated 17 years, 4 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
I have finding been that when I have been replacing these boots the gap on the new one is larger than the gap on the old one. Has any one else had problems here and does any one know of a non-gen boot I can try? In my opinion the machine will be prone to sucking up socks.
ur right, but its because your not fitting them well enough!!
when you fit the seal, u need to ‘curl’ the seal inwards, so it fits closer to the inner tank
ive done a few, just takes practise
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.