Hotpoint WF100 aborting spin.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF100 aborting spin.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 31, 2009 at 5:29 pm #48200
    Madmac
    Participant

    Oooh i just love these things 🙁 This is an admittedly hard used machine, already put bearings in it about 6 months ago. Now its flashing the top option light of the five, & rapid flashing the on/off light.
    Seems to fault when ramping up to spin. Am i right in thinking its an F8 fault & new board required? Doubt my punter will go for it if so 🙁

    Thanks, Eddie.

    September 3, 2009 at 9:15 am #295929
    Madmac
    Participant

    Re: Hotpoint WF100 aborting spin.

    Returned to this thing yesterday, took the panel off & tapped each relay with the handle of a screwdriver, also tweaked up the edge connectors.
    Bloody things going fine now! Im sure it wont last as my suspicion is a relay rather than edge connectors but thought i’d share the tip 🙂

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.