Hotpoint WF100 dead.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF100 dead.

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • November 4, 2011 at 4:19 pm #66086
    iadom
    Moderator

    Power to main PCB, no lights on dispaly at all, no visual damage on console PCB.

    Main board has just come back from EMW as NFF.

    Not had a facia board cause this fault, has anyone seen this?

    Motor/doorlock both OK.

    Jim.

    November 4, 2011 at 6:42 pm #362998
    johnnyj
    Participant

    Re: Hotpoint WF100 dead.

    I’ve had a couple of duff console boards do this, i usualy plug in another similar boaard if i havent got correct one to confirm, J

    November 4, 2011 at 8:00 pm #362999
    iadom
    Moderator

    Re: Hotpoint WF100 dead.

    Sadly I don’t have a duff board to try. 🙂

    Thanks anyway Johnny. 🙂

    November 4, 2011 at 8:49 pm #363000
    A1engineer
    Participant

    Hotpoint WF100 dead.

    Console pcb is safe bet m8

    November 4, 2011 at 10:27 pm #363001
    iadom
    Moderator

    Re: Hotpoint WF100 dead.

    I will get my microscope on the small switch solder joints before I entrust it to EMW. 🙂

    November 7, 2011 at 9:55 am #363002
    iadom
    Moderator

    Re: Hotpoint WF100 dead.

    Called back to this one early this morning. 🙂

    Although the joints on the tiny On/Off microswitch looked OK to the naked eye I applied a small blob of solder to all connections and it burst into life. 8)

    Jim.

    November 7, 2011 at 1:43 pm #363003
    A1engineer
    Participant

    Re: Hotpoint WF100 dead.

    job well done then m8, will need to bear that in mind as ive had a few of these faulty.

    November 7, 2011 at 4:51 pm #363004
    franz
    Participant

    Re: Hotpoint WF100 dead.

    is there an echo in here? 😀

    November 7, 2011 at 5:16 pm #363005
    iadom
    Moderator

    Re: Hotpoint WF100 dead.

    franz wrote:is there an echo in here? 😀


    I can’t hear anything. 😉 😀

    November 7, 2011 at 5:26 pm #363006
    franz
    Participant

    Re: Hotpoint WF100 dead.

    you’re a very bad man Jim.
    Franz 😉

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.