Hotpoint WMA36

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMA36

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 1, 2009 at 7:32 pm #49004
    OLLIE2806
    Participant

    Got a hotpoint WMA36,

    M/C spins just a short sharp burst each time then stops, Everything else is working fine, tried a different motor still the same. PCB?

    Thanks.

    October 1, 2009 at 7:42 pm #298463
    johnnyj
    Participant

    Re: Hotpoint WMA36

    Have you checked the harness for any breaks in the wiring or chaffed wires, chaffing on the balance weight, thats the usual culprit on these. JJ

    October 1, 2009 at 7:52 pm #298464
    OLLIE2806
    Participant

    Re: Hotpoint WMA36

    Cheers JJ, I did find a few Chaffed wires and repaired them – Still no Joy,

    October 2, 2009 at 7:16 am #298465
    suedehead1
    Participant

    Re: Hotpoint WMA36

    taco or pcb

    October 2, 2009 at 9:52 pm #298466
    whitevanman
    Participant

    Re: Hotpoint WMA36

    motor plug ?

    October 3, 2009 at 8:50 am #298467
    DDSDDS
    Participant

    Re: Hotpoint WMA36

    sometimes found this to be a burnt track on the board

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.