Hotpoint WMA50

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMA50

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 13, 2009 at 7:45 pm #43456
    ChrisR
    Participant

    I`ve changed the door lock and door handle on this machine to rectify a fault where the machine will work for a sort time then stop with the door lock light flashing.

    Changing the above parts has made no difference.If i hold the start button down for 20/30 seconds it starts again but stops after a short time.

    I suspect pcb but has anybody had this before?.

    Thanks.

    Chris.

    February 13, 2009 at 7:49 pm #277300
    johnnyj
    Participant

    Re: Hotpoint WMA50

    Sounds like the pcb i’m afraid, mind and check the wiring around the front balance weight, tie it up out off the way.

    February 15, 2009 at 8:12 pm #277301
    ChrisR
    Participant

    Re: Hotpoint WMA50

    Thanks Johnny.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.