Hotpoint wml560p not filling/spinning panel??

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hotpoint wml560p not filling/spinning panel??

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 2, 2011 at 3:17 pm #60721
    yam-wr400f
    Participant

    Hi
    please can you advise, hotpoint wml560p washing machine top front panel lights illuminating, door locks and nothing!
    Presumed inlet valve which has just been replaced….. no joy.

    Has a pcb board down left side front could this be blown? is there a fuse on this board?
    wopnt do anything, spin, pump or let water in but top front lighting up o.k.

    HELP!!!!!

    February 2, 2011 at 4:21 pm #343343
    iadom
    Moderator

    Re: Hotpoint wml560p not filling/spinning panel??

    Why did you ‘presume’ the inlet valve was faulty. 😕

    No fuse on PCB, Google for EMW or be prepared to pay huge amounts of money for new PCB, smart card and smart card reader which would leave you with little change from £175.00 or more. 😥

    February 2, 2011 at 5:04 pm #343344
    Specialist01269
    Participant

    Re: Hotpoint wml560p not filling/spinning panel??

    Unfortunately Hotpoint / Indesit electronics are not known for their quality and appear to commit suicide for very little reason. Your best bet would be to either try EMW to get the PCB repaired or looking at a replacement machine. If your going to open the machine please remember power off & plug out first.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.