How to configure module on zanussi ZWC1301

[snig]

Ordered a module for this machine but it doesnt appear to be configured.Anyone have any info on these ?
service code 91490402900

[electrofix]

there are 2 part numbers for the board. One configured one not

132 40 17-60 / 5 not configured

97391490 40 29-00 / 1 configured

which one have you got ?

Dave

[snig]

The one i have is 1324017712 so different again. When powered up all lights flash so assumme not configured, and possibly wrong board ?
Is it possible to configure these ourselves or just send it back ?

[electrofix]

no you cant configure them yourselves

if you notice the part no of the confiured board is a 973 followed by the prod no. that how you tell its a configured part

Dave

[snig]

Interesting about the 973 . didn’t know that. I’ll send it back. As a side note, since fitting the original board back it seems to be working ok ???

[electrofix]

what was the fault ?

Dave

[snig]

Programme would abort after about 2 mins.Tested everything, meggered motor and element. No fault found so ordered pcb.
Left for customer to use and test before i do anything else

[electrofix]

when it aborted did it go off or all lights stayed on and just stopped ?

Dave

[snig]

lights stay on.End light flashed

[electrofix]

all i was thinking was power supply faults and it not that or light would be out

Dave

[Author]

Posts