How to replace F&P GW711 motor controller board?

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › How to replace F&P GW711 motor controller board?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 13, 2009 at 4:20 am #48548
    frank68
    Participant

    Hi is there any spacial procedures to replace F&P GW711 motor controller board?
    Do I need to enter the setup or do adjust anything through the control panel?

    Or ,Just plug all the cables and turn it on!

    Many thanx

    September 16, 2009 at 2:26 am #296918
    bigsmokepiker
    Moderator

    Re: How to replace F&P GW711 motor controller board?

    Size Setting has to be Set
    Power on at Wall Power off At Machine
    Press&Hold TEmp up & Power
    Press spin speed up until spin hold LED is lit
    Press power to confirm setting

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.