HTP x2 WMUD 962 942 Pressure switch reset

[garn]

HTP x2 WMUD 962 942 Pressure switch will not reset.

hi been out on 2 of these appliances last night after 6 pm booking :rolls:

1one WMUD 962 bra wire in pump changed the pump the appliance will not fill.

2one wmud 942 removed money in sump. will not refill with water.

iv tried jims notes on the reset 1ltr water to prime it. even 2lts and a bowlful full of water. no joy.

i can get the valves to open by blowing air into the pressure switch and connecting the pipe quickly but it stops filling .

❓ if i order a replacement pressure switch do you think it going to cure it

its was 9 pm when i got home last night after fiddling with these buggers
Paul…

[HotDog]

Re: HTP x2 WMUD 962 942 Pressure switch reset

sometimes you have to set and leave the machine for upto an hour and they can then start to work,but if that fails you need hotpoint to re-prog the board, but to be honest its never worked for me dont waste anymore time on it forget changing p/sw

[garn]

Re: HTP x2 WMUD 962 942 Pressure switch reset

Thanks very much for the advice .B E R it them. Iv been all ready competing with argos to repair it .
Thanks Paul

Sent from my GT-I9505 using Tapatalk

[garn]

Re: HTP x2 WMUD 962 942 Pressure switch reset

Just wondering hotdog said i would need hotpoint top prog the board.
I have the card reader and lower end adapter is this when this kit comes it ?
If i purchased thae card to program in it may cure it.
Paul

Sent from my GT-I9505 using Tapatalk

[Hollytree_Technical]

Re: HTP x2 WMUD 962 942 Pressure switch reset

Or ask EMW to do it.

Jem

[garn]

Re: HTP x2 WMUD 962 942 Pressure switch reset

Ok thanks.

Sent from my GT-I9505 using Tapatalk

[HotDog]

Re: HTP x2 WMUD 962 942 Pressure switch reset

If you have the card/reader then give it a try

[Author]

Posts