Ignis ADL 943 fault code 7

[lefty74]

Hi,

I have a fault in my Ignis ADL 943, where it flashes 7 times repeatedly. I’ve turned it off overnight and turned it back on again this morning and the issue is still there. I’ve also tried all sorts of combinations of holding down the start button when I turn it on, or set a program, and just holding down the start button for over a minute, but I can’t seem to reset it. The arms are intact and the drain is clear so I’m not sure what the problem could be. I don’t have a manual as it was in the house when I moved in, and I haven’t been able to find one online so I can’t diagnose it myself.

Any help would be greatly appreciated…

[1totalshambles]

Re: Ignis ADL 943 fault code 7

Can`t find ADL943 but can find Adl934. THINK your Ignis is a whirlpool ( should be a label on the s/steel door right hand side with a long set of numbers starting with 85 ) and if so it`ll probably be what is called the flow meter at fault which is a magnetic water counter ref time found behind the left hand side chassis side panel. Your looking at a semi transparent water chamber where the water shoots through it. There should be a connector block with 2 thin wires going to a little pcb / reed switch and it is located above the impellor counter`s moulding. You could first try giving it a light bash (!) and also check the 2 wire terminals. The reed switch often will read ok via an Ohms meter but is still the fault if open circuit Bobs ya uncle!. You`ll have to double check your model number on this one but the part is about 60 quid for the model as above I looked up ……not cheap for what it is but if it fixes the thing well, hey!

[Author]

Posts