ISE 5 mk 1 no heat.

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE Forum (Closed) › ISE 5 mk 1 no heat.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 15, 2008 at 9:56 am #38109
    iadom
    Moderator

    For the knowledge base. 🙂

    Complaint of no heat but machine completes full cycle. Machine about two years old.

    Caused by badly burnt connector block at the PCB end, the two Grey wires to heater.
    PCB appeared undamaged.

    Jim.

    July 15, 2008 at 11:04 am #257750
    Goatboy
    Participant

    Re: ISE 5 mk 1 no heat.

    iadom wrote:PCB appeared undamaged.

    Coolio 😀

    Double-ard PCB’s!

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.