Lamona dishwasher LAM8603 — Not filling

[asp11]

The valve meters out fine, wiring to it is good, as is the wiring generally……….. I’ve fitted a new pcb (1768150021) BUT it made no difference so then I ordered and then fitted an impellor jug…… BUT still doesn’t fill?

On my first visit, after fitting the pcb, I put a bowl of water into the tub AND it drained, filled up and started to wash BUT sadly didn’t repeat this again.

I’ve double checked everything, put all the original parts back on AND CONFUSED….. the 3 items (I think) connected to the filling process have been tried but it still doesn’t fill up — Any ideas please??

[kaibart]

Normally there is a broken wire when they don’t fill the 2 thing black wires are Normally the culprit

[asp11]

kaibart wrote:Normally there is a broken wire when they don’t fill the 2 thing black wires are Normally the culprit

Do you mean the wires from the impellor jug (purple ones) or do the thin black wires go onto something else?
I’m sure the fill valve wires a normal thickness wires?…… In your experience, do they break in the bottom door harness area or somewhere else? I did pull on various wires but nothing appeared broken:(

[kaibart]

I haven’t looked where the wires go to but they are thin wires and brake easy so personally I would check them all front panel off and check them 1 at the time

[DWSERV]

Any weird faults on Beko/Lamona dishwashers first port of call is the wiring harness at bottom of the door

[asp11]

DWSERV wrote:Any weird faults on Beko/Lamona dishwashers first port of call is the wiring harness at bottom of the door

Yes you’re right I really should have looked there but I’ve not had those kind of problems for years now!!??

[Author]

Posts