Lux Ewx14440W Dead

[ray.t]

Hi, I went to this machine about 3 weeks ago, the fault was machine dead, no display or lights etc.
I checked through the machine looked at the interlock no signs of any damage.
I then took the power board off and checked to see if there was any damage, all looked ok so I just tightened up the edge connectors and put it all back.
The machine then worked fine and has been for the last 3 weeks.
Had a call today saying its gone again.
I know this a very long shot but just wondered if anyone had come across this before.
Thanks,
Ray

[Criscold]

Re: Lux Ewx14440W Dead

I presume you have tested that you are getting power to the board on U3.1 & U3.2 and the knob spindle is turning in the switch correctly, if so looks like new board req.

Colin

[suedehead1]

Re: Lux Ewx14440W Dead

had one last week exactly the same board was a silly price, i was hoping someone would have an idea which component may have failed, emw dont fix them and i am reluctant to try qer after several bad experiences.

[Author]

Posts