- This topic has 3 replies, 3 voices, and was last updated 16 years, 10 months ago by
.
-
Posts
-
Went to this job today, customer complained of drain/inlet error. Checked out machine, which drains ok and water enters ok. Checked all filters, inlet and outlet. I started the machine on new cycle, it drained OK and then took in the water to the correct level. It then went into wash cycle for about ten seconds and stopped for about the same and then went back to wash cycle for ten seconds. This continued for about five minutes when the drain/inlet error flashed. I have checked the metering chamber and all hoses on machine for blockages to no avail. Has anybody got any clues to this fault.
Regards
Taff
Re: Miele Dishwasher G686G
had this problem a few weeks ago on a different model .the pressure switch should switch over to the motor if it doesnt you can get this fault or if the wash pump is blocked.i had to change the pressure switch.see link below
Goodluck
http://www.ukwhitegoods.co.uk/modules.p … highlight=either worn or blocked wash pump, but i did come across one with a blocked pressure switch, one too the left of wash motor.
You should hear the pressure switch engage as the wash motor kicks in.
- You must be logged in to reply to this topic.