Miele T294C Dryer stops soon after start

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele T294C Dryer stops soon after start

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 1, 2012 at 9:30 pm #72295
    Latham63
    Participant

    Starts & runs for a minute or 2 on dry progs,then stops Goes to finish, beeping continuously.
    If 15 min.cool down selected,runs normaly until finish.
    Checked heater/stats ok,except the heat sensor(thermistor) reads around 200k ,is this abnormally high?
    Suspect heater fault as runs ok on cooling cycle.

    November 1, 2012 at 9:50 pm #384088
    admin
    Keymaster

    Re: Miele T294C Dryer stops soon after start

    Hi

    There should be carbon resistance sensors that wear way giving this fault on the commercial driers so check if there is any on the top of the drum ass

    Bryan

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.