MW511 – beeps on startup, won’t go into diagnostic mode

[brainfire]

Hi all,

My MW511 was, up until a few days ago, working fine albeit with a slow (and annoying) leak from the cold solenoid into the machine.

It now refuses to do pretty much anything, but perhaps the noises and lights it shows mean something?

– The beep powering it on is very short.
– Shortly after that it beeps 3 times and shows 0100 0000 (across the top) and only the Harm and Hold lights.
– Pressing Power again results in 4 beeps and the machine shows only the Cold light.

I can’t see anything like this in the forum, but perhaps I’m not searching on the right terms?

Any help gladly appreciated!
bF

[Author]

Posts