- This topic has 1 reply, 2 voices, and was last updated 19 years, 2 months ago by
.
-
Posts
-
Hotpoint wd61p dispenser hoses. I have replaced the bearings and cannot find the diagram i made of the hose routing can anyone help as to where they should go?
Re: pipes
There is absolutely no need whatsoever to take these hoses, the heater box or the soap dispenser off when doing a bearing repair. 😥
There are two different soap dispensers used on this model and the hoses fit in different places, on one model the rinse aid dispenser is a white removable container that sits at the back of the soap drawer, on the later model the rinse aid dispenser is a blue cage that is situated at the front of the soap drawer.
Looking from the back the single (hot) valve hose goes onto the left hand nozzle of the soap drawer. On the triple valve, the solenoid that should have two grey wires on it is the condenser valve, the hose on that should go to the the short ribbed hose, top dead centre at the back of the machine. The other two will be the ones you will struggle with, they both have black and blue wires. You may be able to see FC L on one black wire and COLD L on the other. You will have to look at the channels on dispenser top and decide which of the hoses goes where, the FC L wire is for the fabric conditioner valve, the COLD L wire is for the cold fill valve.
One very good reason why this type of job is best left to an expert. 😉
Be sure to remove the mains plug before you go ahead.
Jim.
- You must be logged in to reply to this topic.