Re Bosch Stand Alone Siver Dishwasher display dies and reset

[ashfordkent]

Hi all. Bosch Stand Alone Siver Dishwasher, SGS43E08GB/43 Set prog say long Auto wash 130 mins. Display fades and Dies, Tap panel infront of Board Comes back but if say it had reached 120 mins Comes back on reset to 130 min. Checked for loose connections edge connectors all ok! Door switch 2 wires only to stop machine when door opened.Suspect Control Module. Anyone had same cheers

[Simon46]

Re: Re Bosch Stand Alone Siver Dishwasher display dies and r

Long shot just check the plug isnt stuck to back of dishwasher?

S.

[ashfordkent]

Re: Re Bosch Stand Alone Siver Dishwasher display dies and r

would that cut prog and make it reset back to start

[Martin]

Re: Re Bosch Stand Alone Siver Dishwasher display dies and r

Beware the 491662 control module, prone to board failure from a faulty dispenser solenoid thingy. Close look at component side advised. 😉

[ashfordkent]

Re: Re Bosch Stand Alone Siver Dishwasher display dies and r

It seems to be filling ok correct amount of water. Washes for a while then display goes, machine stops, tap front near pcb and it starts up again but goes back to its original length in Time.

[Penguin45]

Re: Re Bosch Stand Alone Siver Dishwasher display dies and r

Power supply on pcb. Get the soldering iron out. If that don’t do it, new pcb.

Chris.

[roy1]

Re: Re Bosch Stand Alone Siver Dishwasher display dies and r

Had same problem faulty board sent back to QER for repair.

[Author]

Posts