Removing Built in and replacing with standalone dishwasher

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Removing Built in and replacing with standalone dishwasher

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 4, 2006 at 8:06 pm #14528
    Gunner
    Participant

    Hi all,

    I would like to remove our built in Slimline dishwasher (Zanussi Aquasave ZT-485) and replace it with a Bosch Slimline model. (standalone)

    Can anyone advise if the space left after removing the Zanussi will be enough to fit in the Bosch?, without a lot of dishwasher stiocking out the front?

    I realise that I will have to modify the bottom plinth.

    Regards & thx in advance.

    Mark

    January 4, 2006 at 9:34 pm #159780
    Dave_Conway
    Participant

    Re: Removing Built in and replacing with standalone dishwash

    It should be OK, but I would check the dimensions on the Bosch website then measure your gap to be on the safe side 😉

    Dave.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.