Removing oven door – Indesit Oven FM1 IX

Home Forums Public Support Forums Help And Support Cooker And Oven Forum Removing oven door – Indesit Oven FM1 IX

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #7966
    Ianott
    Participant

    I’m trying to clean an Indesit oven (Model FM1 IX is the only information available on the model number), and I can’t figure out how to remove the oven door. I’m sure oven doors are meant to be removable for cleaning, but I don’t have a manual.

    I called their service centre. They refused to explain how it could be done and insisted on booking a service engineer. The oven is working without any problems, so I think it would be a waste to get a skilled engineer over to remove an oven door.

    Can anyone help?

    Thanks!

    Ian

    #126196
    Dave_Conway
    Participant

    Re: Removing oven door – Indesit Oven FM1 IX

    Ian, have a look at the Bosch website explanation here:

    http://www.bshappliancecare.com/Bosch/Bosch_20773.html

    There’s a couple of short videos there about it, one of them should be pretty much like yours as there’s only a couple of types of hinge generally used.

    Dave.

    #126197
    admin
    Keymaster

    Re: Removing oven door – Indesit Oven FM1 IX

    if you open the oven door down fully you should be able to see a clip on either hinge that will come up.( you may need to use a screwdriver to move it )as it lifts up fully on both sides it will lock the hinges when you then try to close the door.

    as you close the door gently lift and move the bottom of the door away from the oven and it should come away freely,replacing will be the reverse of above.

    hope this helps

    bryan

    #126198
    Ianott
    Participant

    Re: Removing oven door – Indesit Oven FM1 IX

    Hi everybody,

    Thanks very much for your suggestions. The door is now off! This site is invaluable.

    Once again, thanks very much.

    Ian

    #126199
    wreckit
    Participant

    Re: Removing oven door – Indesit Oven FM1 IX

    Buddy,

    Don’t get too excited yet. The job is not yet done until you manage to put it back.

    wreckit

    #126200
    Penguin45
    Participant

    We would have heard the screams by now – check the posting date……..

    Penguin45.

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.