resetting e90 on zanussi zwf1437

[admin]

zanussi zwf1437
hi
its been a very long day and my last job was a pain in the…bum

when i got there the machine had ELE stuck on the dial,found out
that to hold the buttons on the front down skip.and start buttons
this rid it of the ele, up pops e90, com error on the pcbs,cleaned up and re bent pins in blue lead to pcbs.

i can not get rid of the e90 on the display,should i be pushing the buttons again, tryed as i did to get rid of the ele, but no joy.

thanks

canufixit

[Seamy]

Re: resetting e90 on zanussi zwf1437

If it had ELE on display it seems someone was at it prior to you looking at it as it should’nt be in diagnostic mode, ELE means the last fault was power has been disrupted. E90 means its not recognising the position of the dial or the PCB configuration is wrong, wrong PCB for appliance for instance, or thats its corrupted. To reset the faults simply hold in the 2 buttons that you held to access faults codes, hold in buttons for a few seconds while in position 10 for reading faults. It should clear & read E00 if you’ve done it correctly.

[admin]

Re: resetting e90 on zanussi zwf1437

thanks,i think he had been pushing buttons before i got there :rolls:,looking at info from the net,and having a go him self

what do you mean position 10 ❓ hows that done
hold in buttons for a few seconds while in position 10 for reading faults. It should clear & read E00 if you’ve done it correctly.

canufixit

[Seamy]

Re: resetting e90 on zanussi zwf1437

Position 10 is basically the position you read error codes in, so if you see E90, hold in the two buttons & faults should clear, clearing fault codes doesn’t repair the problem though, it just removes them from memory.

[admin]

Re: resetting e90 on zanussi zwf1437

thanks

canufixit

[Author]

Posts