servis m6135

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › servis m6135

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 20, 2010 at 10:55 am #55956
    machineman
    Participant

    module blown so replaced it all ok
    cust phones following day m/c does the whole prog fine but keeps on pumping forever at the end of a wash until they turn it off
    totally stumped
    Dave

    July 20, 2010 at 12:53 pm #325732
    DDSDDS
    Participant

    Re: servis m6135

    does it actually spin the clothing fully?

    July 20, 2010 at 1:07 pm #325733
    timdowning
    Participant

    Re: servis m6135

    I’m sure there was a batch of that model that had that fault. (between certain serial numbers.) Changing the module was the cure.

    Was it a new module or recon ?

    July 20, 2010 at 1:23 pm #325734
    machineman
    Participant

    new. we also ordered another, and put that one in and it did exactly the same M6135
    S/N 20015124366
    Dave

    July 20, 2010 at 1:26 pm #325735
    machineman
    Participant

    Yes it goes into a full fast spin
    Dave

    July 20, 2010 at 3:47 pm #325736
    robbra
    Participant

    Re: servis m6135

    Either programme selector or facia pcb. I have taken selectors apart and tweaked the tags inside and sometimes they come good but not always.
    pcb 502020600
    selector 502016600
    Also some ribbon cables can short
    Last thing, is it being reset to “off” when switched on to clear the memory.
    power on, selector to off, power off then on again for 10 secs. Sorry if you know this 😆
    Rob

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.