Sharp R7A50 Microwave tt motor &oven light on all time

Home Forums Trade Technical & Spare Parts Forums Trade Technical Enquiries Sharp R7A50 Microwave tt motor &oven light on all time

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #61397
    fk
    Participant

    🙁 Hi Guys
    I have a Sharp R7A50 microwave, I have been on the sharp basic microwave course, ( ie I know the 3 D’s and the high voltage dangers )
    the problem seems to lie with the DPC as I do not have a manual for this onecan anyone give me a reminder.
    Have eliminated door switch and relay 1 both ok?

    #345966
    loopey
    Participant

    Re: Sharp R7A50 Microwave tt motor &oven light on all ti

    ah been cought out on this one to have a look at the cam that opens and shuts the flap to the microwave cavity air flow it may have melted stopping the cam to switch off to the stop position , it wont finnesh till it does ..
    hth l not sure on that model thow 🙂

    phil

    #345967
    fk
    Participant

    Re: Sharp R7A50 Microwave tt motor &oven light on all ti

    Thanks anyway loopey
    This is my own one at home I got as far as the digital programmer circuit but have not worked on one of these for a while. Anyone help with electronics think it may be transister? 🙁

    #345968
    pete909
    Participant

    Re: Sharp R7A50 Microwave tt motor &oven light on all ti

    hi
    does this happen when the door is open or shut,
    also does this happen when in standby mode

    #345969
    fk
    Participant

    Re: Sharp R7A50 Microwave tt motor &oven light on all time

    Think you can help pete909 ?
    The tt motor and light are on all the time as soon as swithhed on at the socket.

    #345970
    Gordy29
    Participant

    Re: Sharp R7A50 Microwave tt motor &oven light on all time

    check door micro switchs and the door latchs

    #345971
    electrofix
    Moderator

    Re: Sharp R7A50 Microwave tt motor &oven light on all time

    check printed circuit board for damage and check for earth faults

    Dave

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.