- This topic has 1 reply, 1 voice, and was last updated 7 years, 7 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Fitted a new pcb in feb 2018 for a different fault….. but now this machine heats during a wash cycle, opens the dispenser flap, washes fine but does not get hot at the end of a cycle, so is not drying the dishes very well.
No obvious heat in the tank a few minutes after the end of a short cycle….. the heater must be alright, so is it a pcb fault??
Any help on this would be great.
Thanks
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.