Siemens dw dead

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Siemens dw dead

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 20, 2018 at 3:15 pm #95182
    mapelectrical
    Participant

    SN26M8300GB28

    I have power to the main board but display dead.
    No signs of burnt out tracks on board.

    Any ideas?

    December 20, 2018 at 10:08 pm #459635
    timdowning
    Participant

    The few I’ve had of this range being dead have always been
    the main module rather than the programme selector module. There’s a chip on them that fails.

    December 20, 2018 at 10:15 pm #459636
    electrofix
    Moderator

    have you checked board power supply.

    assume by power to the board you mean 240v not low voltage

    normally blows low value resistor when it goes

    Dave

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.