Siemens Hydrosensor – No water coming in.

[Stranah]

Siemens Hydrosensor SE65A560GB/17

My last wash seemed to be proceeding normally (I found the tab half disolved at the end) then it seems that the water stopped filling and the washer continued the cycle without any more water and drained off the existing water as if it had finished like normal but leaving the plates partially cleaned.
I tried the wash again but this time no water is coming in at all but I can hear the motor running…

Any help would be very much appreciated.

Thanks

[gegsy]

Re: Siemens Hydrosensor – No water coming in.

Hi
I would be looking for the usual crud build up in the metering unit,rigid pipe from that unit to sump and the air break in the water matrix on the lhs.
Numerous postings about this to explain location etc 😉
Power off if you are to investigate :plug:

Greg

[Penguin45]

Re: Siemens Hydrosensor – No water coming in.

There’s an article with piccies waiting to be published somewhere in the system, too……

Penguin45.

[Author]

Posts