Siemens S9E1S Dishwasher

[admin]

I have a Siemens dishwasher model S9E1S.
A few days ago, it flooded, since the door wasn’t closed properly.
Now it shows ” F ” in the display.
When I start any program, it starts letting out water, allthough there is none in the machine.
If I feed it with water, it will run program to end, if I don’t, the above mentioned fault code appears.
It seems to me, that it doesn’t let any water in..
Is there a way to reset the program, because it seems to be stuck.

Hope someone can help with this!

Thanks

Niki

[Martin]

Re: Siemens S9E1S Dishwasher

Niki,

Whilst I do not recognise the model number you have given us, I believe it’s likely the floor pan of your machine is flooded.

Firstly disconnect it from the electricity supply, pull the machine forward slightly, then tip it backwards by about 45 or 50 degrees. That should allow any water that has collected in the floor pan area to drain off out of the back (Have a towel handy to mop up 😉 )

Let me know how you get on 🙂

Martin

[admin]

Re: Siemens Dishwasher

Sorry about the wrong model code..
Here is the real one: SE 26 231 DK

I’ll try to tilt the machine when I get home from work…will let you know how it goes.

Niki

[Martin]

Re: Siemens Dishwasher

Niki wrote:Sorry about the wrong model code..
Here is the real one: SE 26 231 DK

Ah! A Danish model, very good, :tup: well the same instruction applies as it is similar to the UK versions nonetheless 😉

Let us know if you have any further problems then 🙂

Martin

[Author]

Posts