- This topic has 1 reply, 2 voices, and was last updated 17 years, 6 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Went to have a quick look at this yesterday. The fault is after a while it’s switched on the spinning and rinse light start flashing. According to the book it means not heating within a specified time. Element is not open circuit and no dry solder joints on the board. Customer claims she can feel heat on the door after it stops but i haven’t verified this myself.
Any ideas?
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.