- This topic has 1 reply, 2 voices, and was last updated 17 years, 9 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hey!
I have found the mains suppressor to be faulty (blown and split) causing appliance not to operate. Since replacing it there is now a new fault of ‘overfilling’…. the inlet will not stop… i am suspecting the suppressor has caused a pcb fault as this was no problem previous and no obvious fault with pressure stats etc found…Also i have removed the pcb and checked it over for ‘blow’ marks but not found any.
Can someone please confirm my suspicions about a board fault?
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.