- This topic has 0 replies, 1 voice, and was last updated 14 years ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi,
Can anyone please advise me on this problem? I have no error lights flashing. Machine turns on as normal but will not run any cycle. I choose the cycle, close the door and the pump makes a noise as if it’s about to start then immediately stops, followed by a beep. This then continues constantly at one second intervals. I’ve just had an engineer round who says he doesn’t know what it is but could be the pcb board but was reluctant to get involved!!! I’ve tried resetting the machine by switching on and pressing the button four times as advised and tried all cycles. Non of them work. Any ideas please?
Regards
Andy
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.