- This topic has 0 replies, 1 voice, and was last updated 17 years, 10 months ago by
.
-
Posts
-
Few months back our dishwasher stopped heating water.. After my last post it was suggested that maybe the door sensor needed replacing..
basically I decided to buy a new door temp sensor, element and element temp sensor.
The prob is this.. I removed the old element and element temp sensor several months ago and have lost the piece of paper I wrote the connections down on.
I have 1 connector with 2 red wires, 1 connector with a brown and 2 connectors that are white but seem to act as a bridge.
Can anyone advise which 2 connectors attach to the element and which 2 connect to the element temp sensor..I would really appreciate some assistance on this, otherwise Im going to scrap it. Im at the point now where if this dont work it must be the pcb which can go swing.
- You must be logged in to reply to this topic.