SMEG WMI12C7 stops mid cycle and clicks

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › SMEG WMI12C7 stops mid cycle and clicks

Viewing 1 post (of 1 total)
  • Author
    Posts
  • March 15, 2014 at 2:05 pm #79960
    edeems
    Participant

    Help and advice requested with my 2 and a half yr old SMEG washing machine.

    On all settings, machine will stop once full of water and about to spin or drain. There are no error codes displayed, just a clicking noise coming from the control dial. The stopping happens at different times through the cycle – no consistency at all.

    If I turn off the WM at the wall, leave for anywhere between 5 to 20 minutes and turn back on again, it will start up, but only for maybe 2 to 5 minutes before stopping again. LED screen goes blank and the clicking starts again. Any ideas?

    I live in a hard water area, and all was fine until I used a de-scaler to clean things up on the inside. The washing machine is not overloaded either.

    Thanks

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.