- This topic has 0 replies, 1 voice, and was last updated 14 years, 3 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi all,
Above machine has seen maybe 6/7 years of hard (family) use. Working perfectly OK but sounding a bit ‘swishy’ on each revolution, so I’m thinking maybe a good time to strip down and service.
Plan is to clean out and replace belt + bearings. Sensible?
On the bearings – are both front ‘felt’ bearing (?) and the rear bearing likely to be worn? And, straighforward to replace?
(I’m quite handy, replaced w/m bearings with the kind help of the experts here :)).
Many thanks!
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.