- This topic has 1 reply, 2 voices, and was last updated 9 years, 2 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Morning folks, We have a Hotpoint washer dryer model number WDPG9640PUK that works fine on the wash cycle but when you put it on the drying cycle it starts filling up with water and comes up with an F13 error, Heater and dryer fan are okay, We have replaced the dryer NTC but problem still persists, before we give the customer the bad news that it is going to need a control module does anybody have any other suggestions ??
Regards Neil
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.