Whirlpool ADG 957 Intergrated

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool ADG 957 Intergrated

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 24, 2008 at 12:13 pm #38966
    swiftboy
    Participant

    Hi,

    Wonder if anyone can help.

    Dishwasher was working fine (5 years old) but water pipe at back became loose and had to be repaired.

    Now dishwasher won’t run cycle. Runs for about 2 mins and then start button keeps flashing. Tried resetting as per the manual – hold start button down for 5 seconds, flashing stops but problem repeats.

    Thanks in anticipation.javascript:emoticon(‘8O’)

    August 24, 2008 at 12:27 pm #260501
    Penguin45
    Participant

    Re: Whirlpool ADG 957 Intergrated

    Count the pattern of the flashing light, ie 1-2-3-4-pause-repeat.

    Penguin45.

    August 24, 2008 at 12:32 pm #260502
    swiftboy
    Participant

    Re: Whirlpool ADG 957 Intergrated

    Hi Penguin,

    The light flashes continuously.


    🙁

    August 24, 2008 at 12:44 pm #260503
    Penguin45
    Participant

    Re: Whirlpool ADG 957 Intergrated

    Constant flashing indicates F1 – this a failure of the temperature sensor device. You’ll need one of THESE.

    Power off if you intend to do this yourself.

    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.