whirlpool adg7340 hose clips

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › whirlpool adg7340 hose clips

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 22, 2006 at 3:47 pm #15029
    tonyr
    Participant

    ok lol no replys to 1st post here goes again 😕
    machine is 2 years old and almost certain the circulation pump is a goner
    but the hose`s on motor are kept on by a clip that i assume have been crimped on at manufacture
    do these clips have to be cut off if so what type of hose clip/fastener to i replace these with
    (the originel clips have a tringlular bit on top and the end of clip is kept in place by 2 barbs)

    any help would save me a fortune cause my 9year old daughter is charging me by the plate to wash up 😯

    cheers
    tony

    January 22, 2006 at 4:43 pm #161747
    Penguin45
    Participant

    Re: whirlpool adg7340 hose clips

    The clip for the pump inlet is replaced by a slimline jubilee clip p/no 4812 401 18157 – about a fiver 😯 IIRC.

    spares@ukwhitegoods.co.uk will get you one……..

    Suggest you counter with taxi fares for school run.

    Regards,
    Pengun45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.