- This topic has 0 replies, 1 voice, and was last updated 18 years, 7 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi Guys,
went to this w/m today, according to customer machine goes through program then advances to start of another program and starts again. Pump ok, heater ok, motor and brushes ok. I did remove brushes, made sure they were not sticking, cleaned them and the comm.Tried machine on spin program and it stopped ok. I am hoping it was just a sticky brush but just in case it’s not, can anyone suggest anything else? Timer?
alanj
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.