- This topic has 0 replies, 1 voice, and was last updated 11 years, 2 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi Guys, this dishwasher comes up with fault F6 E1, when selecting a program it fills so far with water then faults. If you put it on a test cycle it comes up with F6 E7. Have tried a new reed switch in flow meter but no change. Original reed switch seems ok too, have checked it with a magnet. Any ideas optical sensor or board?
Alan
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.